Single Scanner Mode
Single scanner mode is a new feature to LandMap 2.0.
This mode allows you to scan using only one scanner instead of a group of scanners. This is also good for repairing areas without needing to rescan the whole scan group. |
|
| |
Activating Single Scanner Mode
To activate single scanner mode click on [Prim Height] from any scanners main menu and then select a height to use.
It is important to use a prim height you believe will be able to cover your entire land with. For instance if you have a 20 meter tall mountian you will need a prim atleast 20 meters tall.
If you want the edges between sculpties to line up you MUST use the EXACT SAME prim height for every scan so choose carefully. |
|
| |
Using Single Scanner Mode
Once single scanner mode is activated the scanner will turn either green or red. If the scanner is green you can scan immediately by selecting [Scan] from the scanners menu.
If the scanner is red it means that the elevation change accross its scan area is too high for its prim height. To fix this you must reduce your scan size or move the scanner to a different area. |
|
| |
Repairing Sections
If a section of land prims accidentally gets deleted you can use single scanner mode to repair the missing area or areas.
To do this you must set the prim height to the exact height of the other prims in the scan group, then rescan or re-apply your existing sculptie back to the scanner to rebuild the prim. |
|
