The Scanner Display
Above each scanner will be some floating text. This text displays information about the scanner and the scan group. |
|
| |
Free Memory
Displays the scanners current free script memory.
Position
Displays the scanners X/Y position on the simulator.
Scan Area
Displays size of the scan area for the scanner.
N - S - E - W
Displays the distance of each side from the center of the scanner. This is useful if you want to center the scanner in the scan area.
Scan Group
If there is more than 1 scanner on sim they will link together automatically. This line will tell you the group status and how many scanners are in the group if there is one.
My Elevation Change
This is the elevation change accross the scanners scan area.
Prim Height
This is the height of the prim the scanner or scan group will use to make its sculpties with. In the case of a scan group this will be set to the highest elevation in the group.
In single scanner mode this will be locked to whatever you set the prim height to.
Prim Width
This tells you the width of the prim the scanner will use. this is independant to each scanner and will change based on the current scan area size.
Accuracy
This shows you the sculptie resolution error based on the prim height being used. The higher the prim height is, the greater the sculptie error will be and the less accurate your land prims will be.
Try to keep this as low as possible for the best looking results. |
|
